SolderSleeve splices is a one-piece designed, easily installation ,provides insulation, inspection, strain relief and water proof for industrial and home usage. As a salesman for this field for more than 10years from Diocre, I will introduce the install instuction step by step as below.

Totally the innstructions is : Make wires inserted into the terminal, heating with a heat gun, make sure the wires are soldered by the connector, and it will protect wire as a whole new wire, not loosen prematurely.

1.  Peel the two ends of wires with a suitable length to suit the solder splice.

solder sleeve wire splices install instruction step1

2. Joint the two ends of Wires like the pictures, make sure they are connected enough.

solder sleeve wire splices install instruction step 2

3. Move the Solder Splice to cover the joint of wires, especially make sure the solder is exactly covered on the joint of peeled wires. See the picture.

solder sleeve wire splices install instruction step 3

4. Heat the soldersleeve started from one side, slowly heating and moving to the other side.

solder sleeve wire splices install instruction step 4

5. Heating the soldersleeve, make sure it is shrunk enough and not overheated.

solder sleeve wire splices install instruction step 5

6. The complete the solder sleeve wire splices will be look like as below photo.

solder sleeve wire splices install instruction step 6

Now you could enjoy your joint wires, they are very strong, waterproof, one words, as a new whole wire.

If there is anything unclear or you need more information, you could contact us directly.