Nowadays, fiber optic is widely used in our life. Inevitable to need splice fiber cable. How is this progressing? How to heat and fusion fiber sleeve? below tips for single mode fiber splice with picture.

1. splice tools

splice tools

2. through the cable to fiber box

through the cable to fiber box

3 steps of fusion splice. Tip 1: shell cable spoke(about 1meter)

shell cable spoke

Tip 2.

shell cable spoke2

Tip 3.

shell cable spoke3

Tip 4. shell cable coat(about 1meter)

shell cable coat

Tip 5. shell protective layer(cut carefully by knife)

shell protective layer

Tip 6. fold and broke the cable slowly

fold and broke the cable slowly

Tip 7. cutting around cable gently

cutting around cable gently

Tip 8. fold and broke the plastic coat

fold and broke the plastic coat

Tip 9.

fold and broke the plastic coat2

Tip 10 alcohol

alcohol

Tip 11 clean fiber with alcohol

clean fiber with alcohol

Tip 12 cover the fiber optic splice protection sleeve

 cover the fiber optic splice protection sleeve

Dicore fiber splice sleeve

Dicore fiber splice sleeve

Tip 13 shell cable insulation coat

shell cable insulation coat

Tip 14. clean the fiber with alcohol

clean the fiber with alcohol

Tip 15 cut fiber use fiber cleaver

cut fiber use fiber cleaver

Tip 16 put the cutted fiber on fusion splicer

put the cutted fiber on fusion splicer

Tip 17 fixed the fiber

fixed the fiber

Tip 18 cut fiber patchcord to two piece(circle piont) , shell the coat of fiber patchcord(quartz knife )

cut fiber patchcord to two piece

Tip 19 at least 20cm between fiber patchcord outer and inner insulating coat

at least 20cm between fiber patchcord

Tip 20 use alcohol to clean the fiber

use alcohol to clean the fiber

Tip 21 cut fiber fiber patchcord

cut fiber fiber patchcord

Tip 22 put the fiber fiber patchcord to fusion splicer(need aligning with the fiber)

put the fiber fiber patchcord to fusion splicer

Tip 23 fixed fiber patchcord

 fixed fiber patchcord

Tip 24 press “SET” begin fusion fiber

press “SET” begin fusion fiber

Tip 25 automate adjusting

automate adjusting

Tip 26 it will show the wastage after fusion

it will show the wastage after fusion

Tip 27 coat the splice with fiber protection sleeve

coat the splice with fiber protection sleeve

Tip 28 put the covered sleeve to heater

put the covered sleeve to heater

Tip29 press “HEAT”

press “HEAT”

Tip30 take out shrinked fiber

ake out shrinked fiber

Tip31 put the shrinked optic fiber sleeve into closure

put the shrinked optic fiber sleeve into closure

Tip 32 lined and fixed the fiber with insulation tape

lined and fixed the fiber with insulation tape

Tip 33 joint cable to coupler

joint cable to coupler

Tip 34 fixed closure

fixed closure